Allows you to search a variety of questions and answers
On RH-based OS (Centos, Fedora), you can use the ethtool command to set the speed of the port. For example, to set the speed on your eth0 NIC to 100mbps, run the following command:
Code:
ethtool -s eth0 speed 100 duplex full autoneg off
You can do the above for half duplex, 10, 1000mbps speed and for different eth settings. Just have to change the appropriate values in the above command.
To make these changes permanently, just add the following line to your /etc/sysconfig/network-scripts/ifcfg-eth0 (change your eth setting according to which NIC's speed you want to change):
Code:
ETHTOOL_OPTS="speed 100 duplex full autoneg off"
Then issue:
/etc/init.d/network restart
This will reload the network and the new speed will take effect. Depending on how much traffic there is coming through the NIC at that time, it may take up to a minute for this to happen.
Hi Guys and Gals, I'll just say you all are top notch and go above and behind with support. I've tested many other companies none compare to the expertise you all. Previously I would just get a ticked bumped up to a higher level of tier support etc. with AYK everyone is knowledgeable and prompt. Thank you for offering a premium hosting solution. Warm Regards, Johnny
Even though I only have a shared hosting plan, their technical support team responded to my tech support request within the hour, and correctly to boot. (I needed to have a subdomain point to a Tumblr blog by changing the CNAME.)
My first experience with VPS and I din't really know what to do or what to expect. AykSolutions.com team help me and during the entire process, they are patient and problem solving peoples. Cheers,
© 2004 - 2026 AYKsolutions, LLC. All Rights Reserved.
